Oil pan, removing and installing: Removing
- Remove center, left and right insulation trays: → 50 BODY, FRONT
- Unscrew bracket for Secondary Air Injection (AIR) pump motor V101 from oil pan and from cylinder block, -.
- Drain engine oil.
NOTE:
- Observe waste disposal regulations!
- Remove oil pan.
- If necessary loosen oil pan with light blows of a rubber mallet.
- Remove sealant residue from cylinder block with a flat scraper.
- Remove sealant residue from pan with a rotating brush, e.g. a hand drill with a plastic brush attachment (wear protective goggles).
- Clean sealing surfaces. They must be free of oil and grease.