Parts of the ignition, removing and installing (Vehicles with engine code AWD)

The following list pertains to Fig 1.

1. Connector 
   • Black, 4-pin
2. 10 Nm 
3. Ignition coil with power output stage (Ignition Coil 1 with Power Output Stage -N70-, Ignition Coil 2 with Power Output Stage -N127-, Ignition Coil 3 with Power Output Stage - N291-, Ignition Coil 4 with Power Output Stage -N292-) 
   • Checking, see IGNITION COILS WITH POWER OUTPUT STAGES, CHECKING 
4. Spark plug, 30 Nm 
   • remove and install with 3122 B
   • Type and spark plug gap, see TEST DATA, SPARK PLUGS 
5. 3-pin harness connector 
   • Terminals are gold-plated
   • Brown for Knock Sensor (KS) 1 -G61-
   • Black for Knock Sensor (KS) 2 -G66-
6. 20 Nm 
   • Tightening torque affects function of Knock Sensor (KS)
7. Knock Sensor (KS) 1 -G61-* 
   • Terminals of sensor and connector are gold-plated
   • Checking, see CHECK KNOCK SENSORS 
8. Knock Sensor (KS) 2 -G66-* 
   • Terminals of sensor and connector are gold-plated
   • Checking, see CHECK KNOCK SENSORS 
9. Connector 
   • black, 3-pin
10. 10 Nm 
11. Camshaft Position (CMP) Sensor 2 - G163-* 
    • Checking, see CHECK CAMSHAFT POSITION (CMP) SENSOR 
12. 25 Nm 
13. Washer 
    • Conical
14. Face plate 
    • For Camshaft Position (CMP) Sensor 2 -G163-
    • note position when installing
15. Ground (GND) wire 
    • Do not loosen or tighten unless ignition is switched off.
16. 10 Nm 
    • Do not loosen or tighten unless ignition is switched off.
Fig 1: Ignition System Components With Torque Specifications (Vehicles With Engine Code AWD)
Courtesy of VOLKSWAGEN OF AMERICA, INC.