Selector Lever Cable, Removing And Installing: Installing

• Check protective sleeve for damage.

The protective sleeve can only be replaced together with selector lever cable.

• Check that protective sleeve is correctly installed. Do not install protective sleeve twisted.
• Do not bend or kink selector lever cable.

• Selector lever and selector shaft lever are in "P" position and front wheels are blocked.

• Guide selector cable - 3  - into mounting bracket and press onto selector lever - 2  -.
• Install new locking plate - 1  - for selector lever cable onto mounting bracket.

Installation position: 

The angled end of locking plate must face end of selector lever cable.

• Move selector lever from "P" to "2".

• Selector lever mechanism and selector lever cable must move freely. Replace selector lever cable, refer to Selector lever cable, removing and installing  or repair selector lever mechanism as necessary.

• Move selector lever to "P" position.
• Bolt cover with glued-on seal to mounting bracket. When doing this, check position of seal.

• Tighten nuts - arrows A  - to 10 Nm.
• Then tighten both bolts - arrows B  - to 25 Nm.
• Push protective sleeve of selector lever cable into cover.
• Install front and middle heat shields for tunnel.
• Hook selector lever cable into retainer on front heat shield.
• Reassemble exhaust system. Refer to 26 - EXHAUST SYSTEM, EMISSION CONTROLS .

• Hook selector lever cable - 1  - into retainer - arrow  - on engine.

• Loosen bolt - 2  - on front ball socket - 1  - of selector lever cable.
• Place selector lever cable in transmission support bracket and push onto selector shaft lever - 4  - using pliers.
• Install new securing clip - 3  - to selector lever cable at transmission support bracket.
• Tighten bolt - 2  - to 13 Nm.

• Check selector mechanism, refer to Selector mechanism, checking  .