Fuel tank with components, disassembling and assembling: Notes
1 - Connector
- Black, 4-pin
- For Sender for fuel gauge -G- and Fuel Pump (FP) -G6-
2 - Locking ring, 145 Nm
- Check for secure fitting
- Use wrench 3087 to remove and install
3 - Supply line
- Black
- Check for secure fitting
- Secure with spring type clamps
4 - Sender for fuel gauge -G-
5 - Fuel pump
- Removing and installing. Refer to Fuel Pump (FP) in fuel tank, removing and installing
- Checking Fuel Pump (FP). Refer to Fuel Pump (FP) in fuel tank, checking
- Clean strainer if dirty
6 - 2 Nm
7 - Supply line
- Black
- Check for secure fitting
- Secure with spring type clamps
- To fuel supply line at fuel distributor (cylinder bank 1). Refer to Fuel distributor with fuel injectors, disassembling and assembling , Item 1
8 - Fuel filter
- Removing and installing. Refer to Fuel filter, removing and installing
9 - Vent line
- Refer to Fuel tank filler tube, disassembling and assembling , item 16
- Check for secure fitting
- Secure with spring type clamps
10 - Vent line
- Refer to Fuel tank filler tube, disassembling and assembling , item 17
- Check for secure fitting
- Secure with spring type clamps
11 - from connecting hose
- Refer to Fuel tank filler tube, disassembling and assembling , item 18
12 - Union nut, 60 Nm
- Use wrench 3218 to remove and install
13 - Connector
- Black, 2-pin
- To Sender for fuel gauge
14 - Flange
- Note installation position at fuel tank. See Installation position of Fuel Pump (FP) flange
15 - Seal
- Replace if damaged
- To install, place into opening of fuel tank dry
- Only coat with fuel when installing flange item 14
16 - Fuel Supply Sensor 3 -G237-
17 - Mounting clip
- Check for secure fitting
18 - Heat shield
- For fuel tank
19 - Connecting piece
- To connecting hose of auxiliary fuel tank. Refer to Auxiliary fuel tank, removing and installing , item 7
20 - 23 Nm
21 - 10 Nm
22 - Tension strap
- Note installed position
23 - Fuel Level Sensor 2 -G169-
24 - Fuel tank
25 - Return line
- Blue or with blue marking
- Check for secure fitting
- Secure with spring type clamps
- From fuel return line at fuel distributor (cylinder bank 2). Refer to Fuel distributor with fuel injectors, disassembling and assembling , Item 3