Programming and Relearning

Code Control Module (function 07)


NOTE: When replacing instrument clusters, CAN-bus On Board Diagnostic Interface coding must always be performed, regardless if the correct code is already stored/appears in the display after inputting address word 19 - Gate way.


Performing coding for databus On Board Diagnostic (OBD) interface -J533-

- Input address word 19 "Gateway" and then press -> button until "Select function XX" is shown in display.

Indicated on display:


Rapid data transfer HELP
Select function XX


- Press buttons -0- and -7-. This selects "Code Control Module", function 07.

Indicated on display:


Rapid data transfer Q
07 - Code Control Module


- Press -Q- button to confirm input.

Initiating coding

Indicated on display:


Code Control Module
Enter code numbers XXXXX (0-32000)


- Determine code number using code table and enter

Control modules on powertrain data-BUS Code number:
ABS 00002
Airbag 00004

The code numbers for the control modules installed in the vehicle that are connected to the powertrain databus must be added.

Example :
Airbag + ABS:
00004+00002=00006

Indicated on display (example):


6N0909901 Gateway K <-> CAN 0001
Coding 00006 WSC 00000


- Press -Q- button to confirm input.

Indicated on display:


Rapid data transfer HELP
Select function XX


End function:
- Press buttons -0- and -6-. This selects "End Output", function 06.
The tester returns to the "Select function" mode.