Diagnostic Mode 2: Check Operating Conditions

Diagnostic mode 2: Checking operating conditions

Function
This diagnostic mode displays the operating conditions at which an emission relevant malfunction was detected and stored by the Engine Control Module (ECM).

Procedure
- Connect diagnostic tester. Diagnostic Tester, Connecting
- Depending on the desired operating condition:switch on ignition
or
Start engine and let run at idle.
- Under address word 33, select "Diagnostic mode 2: Check operating conditions."
- Select the desired operating condition "PID XX".

NOTE: The operating conditions are sorted by the PID (parameter-identifications).

PID Display operating conditions
03: Condition of the fuel system
04: Calculated load condition value
05: Cooling fluid temperature
06: Short time gasoline-air ratio bank 1
07: Gasoline-air ratio bank 1
12: Engine rotations per minute (RPM)
13: Vehicle speed

- End diagnosis and switch ignition off.