LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volkswagen >> 2001 >> EuroVan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Automatic A/C-Heater Systems) >> Programming >> Programming CLIMATRONIC Control Module (CCM)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Programming CLIMATRONIC Control Module (CCM)

WARNING: This page is about a different car, the 2003 Volkswagen EuroVan and 2002 Volkswagen EuroVan. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Replacement CCM must be programmed after installation. A/C-heater control head display flashes for 15 seconds if control module has not been programmed.
  1. Connect Scan Tool (VAG 1551) to Data Link Connector (DLC) located under left side of instrument panel. Input address word 08, AC/HEATING ELECTRONICS. Press right arrow button until SELECT FUNCTION XX appears on display. Press buttons "0" and "7" to select CODING CONTROL MODULE. Press "Q" button to confirm input.
    NOTE: Code entered will not be loaded into CCM until ignition has been switched off once.
  2. Scan tool will display ENTER CODE NUMBER XXXXX. Using scan tool button pad, enter code (00001). Confirm entry with "Q" button. Scan tool should display control module coding (CODING 00001). Press right arrow button. Scan tool will display SELECT FUNCTION XX. Enter end output function (06). See ENDING OUTPUT  under SELF-DIAGNOSTICS. Turn ignition off and disconnect scan tool.
scientia non olet · About LEMON Manuals