Work sequence

WARNING: This page is about a different variant/trim than selected.

Connect Scan Tool (ST) V.A.G 1551/(V.A.G 1552).
With engine idling, select Engine Control Module (ECM) with "Address word" 01 (Connecting Scan Tool (ST) and selecting ECM → Scan Tool V.A.G 1551 , connecting .)

Indicated on display:

Rapid data transfer HELP
Select function XX

Operate Scan Tool (ST) and advance through program sequence by following display.
Press buttons - 0 - and - 3 - for "Output Diagnostic Test Mode" (DTM).