Amplifier -R12-

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2010 Volkswagen New Beetle, 2009 Volkswagen New Beetle, 2008 Volkswagen New Beetle, 2007 Volkswagen New Beetle, and 2006 Volkswagen New Beetle. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Prior to working on the electrical system:

Obtain the radio system anti-theft code.
Switch off all electrical consumers.
Switch off the ignition and remove the ignition key.
Disconnect the battery. Refer to Removal and Installation .

The amplifier is located behind the left cowl panel cover in the luggage compartment.

Removal

-- Remove the rear cowl panel cover and the left luggage compartment side trim. Refer to Removal and Installation .

-- Remove nuts -1-.

Fig 1: Identifying Nuts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connectors.

-- Push the amplifier up and remove it from the bracket.

Installation

-- Insert the lower part of the amplifier in the guide rail of the bracket.

-- Connect all harness connectors to the amplifier.

-- Screw nuts -1- on and tighten with 10 Nm.

Fig 2: Identifying Nuts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Perform further installation in reverse order.