Work procedure
- Connect the scan tool.
- Start the engine and run at idle.
NOTE:
- If the engine does not start, crank the engine using starter for at least 5 seconds, do not switch the ignition off afterward under any circumstances.
- Select "Mode 5".
- Select the desired "Test-ID" of the component or system that is to be monitored, e.g. "Test-ID 01: Oxygen Sensor Monitor Bank 1 - Sensor 1".
- Select the desired "Test-ID".
The current minimum and maximum values will be displayed on the scan tool screen.
The following table is a numerical list of all "Test-IDs" or "Hex-IDs" that may be selected.
| Test-ID (Hex-ID) | Component or System |
| Test-ID 01 ($01): Test-ID 01 ($01): Oxygen Sensor in Front of Catalytic Convertor Monitor Bank 1 - Sensor 1 | Oxygen Sensor in Front of Catalytic Convertor Monitor Bank 1 - Sensor 1 |
| 08 ($08): Test-ID 02 ($02): Oxygen Sensor Behind Catalytic Converter Monitor Bank 1- Sensor 2 | Oxygen Sensor Behind Catalytic Converter Bank 1 Sensor 2 |