Continuation For All:

-- Using the Go To  button, select "Functions/Component selection" and the following menu options in sequence:

• Body
• Electrical Equipment
• 01 - On Board Diagnostic (OBD) capable systems
• Telematics NAR
• Telematics NAR functions
• Query/erase the DTC memory

-- Switch the ignition off and wait several minutes.

-- Switch on ignition.

-- In VAS 5051B, select operating mode "Guided Fault Finding".

-- Using the Go To  button, select "Functions/Component selection" and the following menu options in sequence:

• Body
• Electrical Equipment
• 01 - On Board Diagnostic (OBD) capable systems
• Telematics NAR
• Telematics NAR functions
• Query/erase the DTC memory

No malfunctions may be present in the memory.

The green telematics control module must illuminate in the Telematics control head -E264-.

-- Disconnect the VAS 5051B from the telematics control module.

Configuration 

-- Drive the vehicle to an open space without buildings and roofs.

-- Press OnStar  button. A sequence of tones is heard.

-- Press the OnStar  button again during the sequence of tones.

-- When the OnStar Call Center responds, identify yourself as VW Service and report that you replaced the Vehicle Communications Interface unit (VCIM) "".

-- Give the OnStar Call Center the ESN and STID of the new telematics control module as well as the VIN and customer data (if necessary).

-- The OnStar Call Center will guide you through the configuration and update the customer data.

-- When the configuration is complete, press the OnStar  button.

-- Wait 10 minutes and press the OnStar  button again to confirm the configuration. Inform the OnStar Call Center that VW Service conducts a quality check after replacement of the VCIM and the configuration.

-- To end the connection, press the OnStar  button.