Service Interval Display, From 05.1999, Resetting

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 Volkswagen New Beetle, 2009 Volkswagen New Beetle, 2008 Volkswagen New Beetle, 2007 Volkswagen New Beetle, and 2006 Volkswagen New Beetle. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Vehicle Diagnosis, Testing and Information System VAS 5051B

The service interval display must be reset at:

Delivery inspection.
Each inspection service.

There are two ways to reset the service interval display:

Using the VAS 5051B under "Guided Fault Finding".

-- Connect the VAS 5051B. Refer to VEHICLE DIAGNOSIS, TESTING AND INFORMATION SYSTEM, CONNECTING .

-- In VAS 5051B, select operating mode "Guided Fault Finding ".

-- Using the "Go To " button, select "Functions/Component selection" and the following menu options in sequence:

Body
Electrical Equipment
01 - On Board Diagnostic (OBD) capable systems
Instrument Cluster
Functions
Adapting the instrument cluster
Service Interval Display, Resetting

Reset the service interval display using the knob -1- to set the trip odometer to zero when the instrument cluster is in "reset mode."

Fig 1: Identifying Adjustment Button For Odometer And Clock At Instrument Cluster

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Initiating the Reset Mode

-- Turn off the ignition.

-- Press and hold the reset button -1- for resetting the trip odometer to zero.

-- Switch on ignition.

-- Release the reset button -1-.

"Service" appears in the display.

-- Press the reset button -1- for approximately 10 seconds until "Service" goes out.

The displayed Service will be reset and the odometer display returns to its standard setting.

-- Turn off the ignition.