Test sequence
NOTE:
Test must be performed within 3 minutes after engine start.
- Start engine and let run at idle.
- Connect V.A.G 1715 multimeter with current probe in succession to wires to glow plugs.
- Specified value on display of V.A.G 1715
at least 6 A.
If specified value is obtained:
- Eliminate error in wires (see circuit diagram):
Refer to Electrical Wiring Diagrams, Troubleshooting & Component Locations
- Erase DTC memory of control module for Diesel-Direct fuel injection system. Refer to Diagnostic mode 4: Reset/erase diagnostic data .
- Generate readiness code.