Air Bag Control Module: Service and Repair

Airbag Control Module J234, Removing And Installing

NOTE:
- Obtain radio code before disconnecting battery.
- After connecting battery, vehicle options (radio, clock, electric window regulator) must be checked according to repair manual and/or user manual.

Removing

CAUTION: Before working on electrical system: Disconnect battery ground (GND) strap.

- Remove center console.
- Remove footwell vent.
- If necessary, cut carpet and insulation mat in area of control module bracket as necessary.
- Move bracket - 2 - in opposite direction of - arrow - and remove harness connector - 3 from control module - 1 -.







- Remove nuts - 4 - and pull control module bracket from studs (nut - 4 - = 20 Nm).

Installing
- Installation is reverse order of removal.

CAUTION: Make sure no one is in vehicle.

- Switch on ignition.
- Close doors.
- Connect battery Ground (GND) strap