Multi-point Connectors on Fuse/Relay panel, Remove/install

Multi-point connectors on fuse/relay panel, removing and installing

Removing





- Pull open locking slide -1 - on back of fuse/relay panel in direction indicated (arrow).





- Depress locking clip (arrow) and pull multi-point connector from fuse/relay panel.





Installing

- Insert connectors so that locking pins -2- fac locking slide -1-.

- Push multi-point connector into appropriate location -4- until locking clip -3- engages.

- When all connectors are installed, push lock slide -1- in direction indicated (arrow) until locked.

Note: Fully insert all multi-point connectors into fuse/ panel before engaging locking slide -1-.