Central locking system, repairing: Notes
WARNING: This page is about a different variant/trim than selected.
NOTE:
The following list refers to Fig 1
.
- - Central locking system pump and control module -V69- (Golf)
- Removing and installing. See CENTRAL LOCKING SYSTEM PUMP AND CONTROL MODULE, REMOVING AND INSTALLING .
- - Fuel tank flap, actuator
- To remove, loosen luggage compartment trim near wheel housing
- Removing and installing. See FUEL FILLER FLAP ACTUATOR, REMOVING AND INSTALLING .
- - T-connector
- Location: near B-pillar/rocker panel, covered by sill molding
- - Rear lid, actuator
- Removing and installing. See REAR LID LATCH ACTUATOR, REMOVING AND INSTALLING .
- - Rear door latch, actuator
- Removing and installing. See REAR DOOR LATCH ACTUATOR, REMOVING AND INSTALLING .
- - Front door latch, actuator
- Incorporates driver's door central locking system switch -F59-
- Removing and installing. See FRONT DOOR LATCH ACTUATOR, REMOVING AND INSTALLING .
- - Multi-pin harness connector
- Location: Near A-pillar
- Also near B-pillar on 4-door vehicles
- - Color marking
- Bi-pressure hoses must be pushed into bi-pressure hose connectors -9- up to color marking
- - Bi-pressure hose connector
- Two types: integral with multi-pin harness connector -7-, or separate
- Integral type: multi-pin connector must be separated to allow connection of bi-pressure hose
- Separate type: bi-pressure hose connector -9- must be pushed back into multi-pin connector -7- after bi-pressure hose is connected
- - Foam tube
- Passenger's side only
- - Front door latch, actuator
- Incorporates passenger's door central locking system switch -F114-
- - Rear door latch, actuator
- - Central locking system pump and control module -V69- (Jetta)
- Removing and installing. See CENTRAL LOCKING SYSTEM PUMP AND CONTROL MODULE, REMOVING AND INSTALLING .