Multi-Pin Plug Behind Relay Plate, Removing and Installing

Multi-pin plug, removing







- Pull the retaining slide -1-, on rear of relay plate, out of housing -arrow- as far as possible (about 5 mm, (.2 in.)).







- Press retaining lug on multi-pin connector -arrow- and pull out of relay plate.


Multi-pin connector, installing







NOTE: Insert connector so that locking pin -2- faces toward locking slide -1-.


- Push multi-pin connector into appropriate location to stop with locking pin -2- located in recess -4- until retaining tab -3- engages.
- Push locking slide -1- against stop -arrow-; only possible when all multi-pin connectors are pushed in to retaining tab -3- engagement.