Removal & Installation: Engine: Installation

WARNING: This page is about a different variant/trim than selected.

To install, reverse removal procedure. Ensure that engine mount front and rear recess is aligned with tabs on mounting bracket. Tighten engine mounts to specifications. See TORQUE SPECIFICATIONS table. Improper engine mount tightening will result in excessive engine vibration and premature engine mount wear.
Install drive shafts. Ensure all wire harness connectors and hoses are connected properly. Install and adjust throttle and cold start accelerator cables. See procedures in ACCELERATOR CABLE and COLD START ACCELERATOR CABLE ADJUSTMENT under ADJUSTMENTS.
Install transaxle shift linkages. Adjust accessory drive belt tension. Fill all fluids to proper level. Bleed air from cooling system. See COOLING SYSTEM BLEEDING . Check for fluid leaks.