LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volkswagen >> 1996 >> Passat GLS, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - Gasoline >> Circuit Tests >> DTC P0103/16487 - MAF Circuit High Input
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC P0103/16487 - MAF Circuit High Input

NOTE: DTC is set when signal from Mass Airflow (MAF) sensor to Electronic Control Module (ECM) is too high.
  1. Inspect MAF sensor connector for looseness and/or corrosion. Repair sensor connector as necessary. Erase DTC memory and test drive vehicle. See CLEARING DTCS  in this article. Recheck DTC memory and verify DTC does not reset. If DTC resets, go to next step. If sensor connector is okay, go to next step.
  2. Check MAF sensor fuse. Replace if necessary. Turn ignition off. Disconnect MAF sensor connector. Disconnect ECM connector. Connect Test Box (VAG 1598/18) to ECM wiring harness. Terminal assignments of test box are identical to ECM connector's.
  3. Using a DVOM, check resistance between MAF sensor connector terminal No. 1 and test box socket No. 1. Jumper MAF sensor connector terminals No. 1 and 2, and check resistance between test box sockets No. 1 and 16. Jumper MAF sensor connector terminals No. 1 and 4, and check resistance between test box sockets No. 1 and 17. Resistance should be less than 1.5 ohms. If resistance is as specified, go to next step. If resistance is not as specified, repair open circuit between MAF sensor connector and ECM. Erase DTC memory and test drive vehicle. See CLEARING DTCS in this article. Recheck DTC memory and verify DTC does not reset. If DTC resets, go to next step.
  4. Remove jumper and check resistance between test box sockets No. 16 and 17. Resistance should be infinite (no continuity). If resistance is as specified, go to next step. If resistance is not as specified, repair short circuit between MAF sensor connector and ECM connector. Erase DTC memory and test drive vehicle. See CLEARING DTCS in this article. Recheck DTC memory and verify DTC does not reset. If DTC resets, go to next step.
  5. Replace MAF sensor. Erase DTC memory and test drive vehicle. See CLEARING DTCS  in this article. Recheck DTC memory and verify DTC does not reset. If DTC resets, go to next step.
  6. Replace faulty ECM. Test drive vehicle. Recheck DTC memory and verify DTC does not reset. If DTC resets, repeat testing procedure.
scientia non olet · About LEMON Manuals