Engine Coolant Temperature Sensor: 2.0L
- Ensure engine is cold. Connect scan tool to Data Link Connector (DLC) located below A/C-heater control panel. With scan tool in READ MEASURING VALUE BLOCK function, read coolant temperature value in field No. 2 of scan tool.
- Temperature value must increase uniformly without interruption. If there is an interruption (open), 77.7°C will be displayed. If coolant temperature value does not change, test circuit using Ground & Power Circuits Check ECM ground and power circuits using appropriate PIN VOLTAGE CHARTS article.
- If necessary, replace ECT sensor. After repairs, erase DTC memory (if applicable) and select END OUTPUT function on scan tool.