LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volkswagen >> 1996 >> Passat GLS, Automatic >> Repair and Diagnosis >> Brakes >> Anti-Lock Brake System & Traction Control >> Bleeding Brake System >> Bleeding Procedures
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Bleeding Procedures

NOTE: Manufacturer recommends bleeding brake system using Pressure Bleeder (US 1116). If a pressure bleeder is not available, use standard bleeding procedure.
  1. Exhaust vacuum reserve from power unit by depressing brake pedal several times. Fill master cylinder with clean brake fluid. If master cylinder was replaced, bleed master cylinder before bleeding wheel calipers. Connect bleeder hose to appropriate caliper bleeder valve. See BRAKELINE BLEEDING SEQUENCE  table.
    BRAKELINE BLEEDING SEQUENCE

    Application Sequence
    All Models RR, LR, RF & LF
  2. Submerge other end of hose in clean glass jar partially filled with clean brake fluid. Pump brake pedal several times, then hold down. Open bleeder valve. Holding pedal down, close bleeder valve. Release brake pedal.
  3. Repeat procedure until brake fluid shows no signs of air bubbles. When bleeding rear brakes, push lever of pressure regulator (if equipped) in direction of rear axle. Ensure master cylinder reservoir is full.
scientia non olet · About LEMON Manuals