LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volkswagen >> 1996 >> Golf 2.0 B, Standard >> Repair and Diagnosis >> Quick Lookups >> DTC Index >> TEVES 20 GI Abs And Abs/EDL On Board Diagnostic (OBD)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

TEVES 20 GI Abs And Abs/EDL On Board Diagnostic (OBD)

Diagnostic Trouble Code Table, Teves 20 GI - DTC 00000

VAG 1551 Scan Tool printout Possible cause of malfunction Repairing malfunction
00000     
No DTC recognized If "No DTC recognized" is displayed after carrying out repairs, On Board Diagnostic (OBD) program sequence has ended.
If, despite "No DTC recognized" being displayed, the ABS system does not operate properly, then proceed as follows:
  • Carry out road test exceeding 20 km/h (12 mph).
  • Again check DTC memory.

If there is still no DTC stored:
Diagnostic Trouble Code Table, Teves 20 GI - DTC 00283

VAG 1551 Scan Tool printout Possible cause of malfunction Repairing malfunction
00283     
ABS Wheel Speed Sensor, LF-G47 Open circuit, short circuit or loose connection in:
  • ABS wheel speed sensor wire
  • Connector
  • ABS wheel speed sensor winding
  • Check wiring, connectors, ABS wheel speed sensor and Ground (GND) wiring to ABS control module
  Short circuit in ABS wheel speed sensor See test steps 6 and 10 (1)
Mechanical malfunction (2) Excessive air gap between ABS wheel speed sensor and impulse rotor (signal not OK)
  • Check installation of ABS wheel speed sensor and impulse rotor; clean if necessary

Read measuring value block, function 08. See READ MEASURING VALUE BLOCK (VAG 1551 SCAN TOOL FUNCTION 08) .
Signal outside tolerances (2) Impulse rotor and ABS wheel speed sensor dirty or damaged  
(1) See TEVES 20 GI ABS AND ABS/EDL ELECTRICAL TEST .
(2) Type of malfunction; this malfunction is only recognized above 20 km/h (12 mph); test drive.
Diagnostic Trouble Code Table, Teves 20 GI - DTC 00285

VAG 1551 Scan Tool printout Possible cause of malfunction Repairing malfunction
00285     
ABS Wheel Speed Sensor, RF-G45 Open circuit, short circuit or loose connection in:
  • ABS wheel speed sensor wire
  • Connector
  • ABS wheel speed sensor winding
  • Check wiring, connectors, ABS wheel speed sensor and Ground (GND) wiring to ABS control module
  Short circuit in ABS wheel speed sensor See test steps 5 and 9 (1)
Mechanical malfunction (2) Excessive air gap between ABS wheel speed sensor and impulse rotor (signal not OK)
  • Check installation of ABS wheel speed sensor and impulse rotor; clean if necessary

Read measuring value block, function 08. See READ MEASURING VALUE BLOCK (VAG 1551 SCAN TOOL FUNCTION 08) .
Signal outside tolerances (2) Impulse rotor and ABS wheel speed sensor dirty or damaged  
(1) See TEVES 20 GI ABS AND ABS/EDL ELECTRICAL TEST .
(2) Type of malfunction; this malfunction is only recognized above 20 km/h (12 mph); test drive.
Diagnostic Trouble Code Table, Teves 20 GI - DTC 00287

VAG 1551 Scan Tool printout Possible cause of malfunction Repairing malfunction
00287     
ABS Wheel Speed Sensor, RR -G44 Open circuit, short circuit or loose connection in:
  • ABS wheel speed sensor wire
  • Connector
  • ABS wheel speed sensor winding
  • Check wiring, connectors, ABS wheel speed sensor and Ground (GND) wiring to ABS control module
  Short circuit in ABS wheel speed sensor See test steps 7 and 11 (1)
Mechanical malfunction (2) Excessive air gap between ABS wheel speed sensor and impulse rotor (signal not OK)
  • Check installation of ABS wheel speed sensor and impulse rotor; clean if necessary

Read measuring value block, function 08. See READ MEASURING VALUE BLOCK (VAG 1551 SCAN TOOL FUNCTION 08) .
Signal outside tolerances (2) Impulse rotor and ABS wheel speed sensor dirty or damaged  
(1) See TEVES 20 GI ABS AND ABS/EDL ELECTRICAL TEST .
(2) Type of malfunction; this malfunction is only recognized above 20 km/h (12 mph); test drive.
Diagnostic Trouble Code Table, Teves 20 GI - DTC 00290 & 00668

VAG 1551 Scan Tool printout Possible cause of malfunction Repairing malfunction
00290     
ABS Wheel Speed Sensor, LR -G46 Open circuit, short circuit or loose connection in:
  • ABS wheel speed sensor wire
  • Connector
  • ABS wheel speed sensor winding
  • Check wiring, connectors, ABS wheel speed sensor and Ground (GND) wiring to ABS control module
  Short circuit in ABS wheel speed sensor See test steps 8 and 12 (1)
Mechanical malfunction (2) Excessive air gap between ABS wheel speed sensor and impulse rotor (signal not OK)
  • Check installation of ABS wheel speed sensor and impulse rotor; clean if necessary

Read measuring value block, function 08. See READ MEASURING VALUE BLOCK (VAG 1551 SCAN TOOL FUNCTION 08) .
Signal outside tolerances (2) Impulse rotor and ABS wheel speed sensor dirty or damaged  
00668     
Battery Positive Voltage (B+) Term.30 Faulty voltage supply wires, connections, fuses 1 and/or 2 for control module-ABS, -S123- and/or -S124-
  • Check fuses, wires, connections as well as battery positive voltage (B+) supply to ABS control module

See test step 2 (1)
(1) See TEVES 20 GI ABS AND ABS/EDL ELECTRICAL TEST .
(2) Type of malfunction; this malfunction is only recognized above 20 km/h (12 mph); test drive.
Diagnostic Trouble Code Table, Teves 20 GI - DTC 01044, 01130 & 01276

VAG 1551 Scan Tool printout Possible cause of malfunction Repairing malfunction
01044     
Control Module incorrectly coded An incorrect code number has been entered via VAG 1551 scan tool
Open or short circuit in wiring harness between terminals 15 and terminal 21
See test step 13 (1)
01130     
ABS operation
Signal outside tolerance (2)		 Electrical interference from external sources (high frequency radiation; e.g. non-insulated ignition cable) Sequence:
  • Check all wiring and connections for short to positive or Ground (GND)
  • Erase DTC memory - Carry out a test drive exceeding 20 km/h (12 mph)
  • Check DTC memory again
01276     
ABS hydraulic pump-V64
Signal outside tolerance (2)
  • Connection electric motor to ABS control module
  • Short to positive or Ground (GND) or open circuit
  • Pump motor faulty
(1) See TEVES 20 GI ABS AND ABS/EDL ELECTRICAL TEST .
(2) Type of malfunction; this malfunction is only recognized above 20 km/h (12 mph); test drive.
Diagnostic Trouble Code Table, Teves 20 GI - DTC 65535

VAG 1551 Scan Tool printout Possible cause of malfunction Repairing malfunction
65535     
Control Module Malfunctioning(1) ABS control module faulty
  • Replace ABS control module
(1) Type of malfunction; this malfunction is only recognized above 20 km/h (12 mph); test drive.
scientia non olet · About LEMON Manuals