Corrado SLC & Passat
- Turn ignition on. Connect Adapter Cable (357 971 514E) to Data Link Connectors (DLC). DLC is located in center console. See Fig 1
. Connect Black end of adapter cable to Black DLC, and White cable to White DLC.
- Leave adapter cable attached for 5 seconds, until on-board diagnostic MIL (CHECK ENGINE light) begins to blink. Remove adapter cable. Allow on-board diagnostic code retrieval procedure to run until Code 4444 (no faults indicated) or Code 0000 (end of output) appears. To end code retrieval procedure, reconnect adapter cable to DLCs or turn ignition off.
- To erase fault codes, turn ignition off. Connect adapter cable and turn ignition on. Leave adapter cable attached for 5 seconds, until CHECK ENGINE light begins to blink.
- When light displays code 4444 (no faults indicated), reconnect adapter cable to DLCs or turn ignition off to end code clearing procedure. Fault memory is now erased.
Courtesy of VOLKSWAGEN UNITED STATES, INC.