Alarm Module: Service and Repair

Alarm system control module -J284-, removing and installing

Removing





- Remove driver's side instrument panel trim.

- Disconnect 6-pin and 10-pin connectors from alarm system control module -J284-, located behind bracket on left A-pillar.

Vehicles withcruise control:

- Disconnect 12-pin connector from cruise control, control module -J213-, located behind bracket on left A- pillar.

Note: The alarm system control module - J284- and cruise control control module -J213- are located on the same mounting plate.

- Remove nut -1 - from assembly carrier.

- Pull mounting plate locking lugs out from bracket and remove mounting plate with control module -2-.

- Remove control module mounting bolts from mounting plate and remove control module.


Install in reverse order of removal.