Service Precautions

Observe these precautions when working with air bag systems:

DO NOT use computer memory saver tool. Using computer memory tool will keep air bag system active and may cause accidental deployment of air bag unit.
Disable air bag system before servicing any air bag system or steering column component. See DISABLING & ACTIVATING AIR BAG SYSTEM.
Because of critical operating requirements of system, DO NOT attempt to service any air bag system component.
Air bag parts should not be left unattended. They should be installed in vehicle immediately after obtaining them.
Air bag components which have been dropped more than 18 inches should not be used.
Chemical cleaners, oil and grease should not contact vinyl covering on air bag unit.
DO NOT place stickers or covers on steering wheel.
Always disable air bag system before performing electric welding on vehicle.
Air bag system can only be tested using Diagnostic Tester (VAG 1551 ). Never use test light on air bag system.

CAUTION: Applying excessive pressure or causing impact to mainshaft during service may cause the column to disengage.