EuroVan (2.5L)
- Connect Scan Tester (VAG 1551) to Data Link Connectors (DLC) located below A/C-heater control panel (in fold-down storage shelf in front of relay panel on EuroVan). With scan tester in READ MEASUREMENT (MEASURING VALUE) BLOCK function, press "00" to "06" buttons to select desired display group. See DISPLAY GROUP (EUROVAN) table.
- When display group "00" is selected, only READ MEASUREMENT BLOCK is shown on display (the zeros do not appear on display). With READ MEASUREMENT BLOCK function completed, select END DATA TRANSFER function on scan tester. Turn ignition off. Disconnect scan tester.
DISPLAY GROUP (EUROVAN)
| Display Group No. & Channel No. | Display Parameters | |
|---|---|---|
| 00 | Used Only For Testing Vehicle At Factory | |
| 01 | ||
| 1 | Engine Coolant Temperature | |
| 2 | Engine Speed | |
| 3 | Oxygen Sensor Signal Voltage | |
| 4 | Ignition Timing | |
| 02 | ||
| 1 | Engine Coolant Temperature | |
| 2 | Engine Speed | |
| 3 | Throttle Angle | |
| 4 | Engine Load | |
| 03 | ||
| 1 | Engine Coolant Temperature | |
| 2 | Engine Speed | |
| 3 | Intake Air Temperature | |
| 4 | Battery Voltage | |
| 04 | ||
| 1 | Engine Coolant Temperature | |
| 2 | Engine Speed | |
| 3 | Ignition Timing | |
| 4 | Engine Load | |
| 05 | ||
| 1 | Engine Coolant Temperature | |
| 2 | Engine Speed | |
| 3 | Throttle Angle | |
| 4 | Battery Voltage | |