Retrieving Codes

1. Turn the ignition ON. Connect the black end of the jumper cable to the black diagnostic connector in center console under shift boot. Connect the white end of the jumper to the white diagnostic connector.
2. After five seconds the OBD CHECK light should begin to flash. Remove the jumper, but do not turn off the ignition. Record the flashes.
3. When code 4444 or 0000 appears, then either turn off the ignition or reinstall the jumper to end code readout.

Possible wiring faults should be checked and corrected before replacing a suspected component. Once the fault is corrected, the permanent fault memory should be erased as described below.