Federal Vehicles (Digifant II)

Power Supply Relay Location:

The Power Supply Relay is located in relay position #3 of the fuse/relay panel, (see diagram). The fuse/relay panel is behind the left side of the instrument panel. For access, pull on the upper edge of the recessed storage bin, then lift out the bin.

To remove the relay, pull straight up on relay to avoid loosening or damaging relay socket connectors. To install the relay, match the position of the relay terminals with the position of the socket connectors, rotate the relay until all relay terminals match all socket connectors then push the relay into the socket connectors.

NOTE: Some vehicles are equipped with a knee bolster to prevent knee injury in the event of an accident. The knee bolster runs along the entire length of the lower dash. To properly access the fuse/relay panel for servicing, the knee bolster must be removed.