Section 22 (Engine Controls - Basic Testing): Introduction
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 1992 Volkswagen Passat, 1992 Volkswagen Jetta, 1992 Volkswagen Golf, 1992 Volkswagen GTI, and 1992 Volkswagen Fox. However, it is still accessible from the selected car via links, so may be relevant.
The following diagnostic steps will help prevent overlooking a simple problem. This is also where to begin diagnosis for a no-start condition.
The first step in diagnosing any driveability problem is verifying the customer's complaint with a test drive under the conditions the problem reportedly occurred.
Before entering self-diagnostics (if equipped), perform a careful and complete visual inspection. Most engine control problems result from mechanical breakdowns, poor electrical connections, or damaged/misrouted vacuum hoses. Before condemning the computerized system, perform each test listed in this article.
NOTE:
Perform all voltage tests with a Digital Volt-Ohmmeter (DVOM) with a minimum 10-megohm input impedance, unless stated otherwise in test procedure.