Gearshift Linkage: Vanagon
- Place gearshift lever in Neutral position. Align round centering holes of upper gearshift lever housing plate with holes in lower lever bearing plate.
- Loosen nut on clamp that connects front and rear shift rods. Ensure joints of shift rods slide freely. Remove spare tire. Set shift lever on transaxle in vertical (Neutral) position.
- At gearshift lever end of front shift rod, ensure stop finger of front shift rod is in center of shift mechanism housing.
- Adjust front shift rod end so there is 29/32" (23 mm) clearance between front shift rod end and stop plate. Tighten shift rod clamp.
- Check for proper operation. Ensure shift lever does not rub against heater pipe insulation.