Remote Control Lock, Removing/ Installing

Work sequence

Removing



- remove screws 1 and 2 from inner and outer door handles
- remove inner and outer door handles and spacer washer



- remove catchplate 3

- remove locking knob 4

- remove door latch plate 5



- remove circlip 6 from remote control lock pin and remove cable 7
- remove screw (arrow) and pull remote control lock out between door inner and outer panels
Installing

- push lock in between inner and outer panels, align catchplate and screw loosely in position
- coat inner and outer door handle fastening screws with Loctite(R) 274 or equivalent and install

- install cable on remote control lock pin and secure with circlip
- tighten lock securing screws

Note

For tightening torques see Fig. 58-235 on preceding page.

- install locking knob