Transaxle & Clutch Assembly: Installation
NOTE:
When replacing clutch components, it is recommended that 190 mm parts be upgraded to latest 200 mm version.
- To install, coat pressure plate bolts with Loctite 270 or 271 (or equivalent) and reverse removal procedure. Align cut-out in flywheel to allow right side drive shaft flange passing clearance (if equipped).
- Ensure large cover plate is properly seated. Retaining ring ends must be between 2 slots in release plate. Use centering tool (VW547 ) to center clutch disc on flywheel. If new flywheel is to be installed, a new timing mark must be cut into flywheel 1/4" (6 mm) to right of TDC mark.