Carburetor - Carter-Weber Single Bbl: Overhaul: Disassembly

NOTE: Some carburetors may not have all parts referred to in following procedures.

Remove carburetor from vehicle. Remove choke vacuum hose and banjo fuel line assembly and gaskets. Remove idle stop solenoid and fuel line bracket. Remove feedback and bowl vent solenoids, spacers and gaskets. Remove pick-up armature and spring from bowl vent solenoid.
Remove connector rod and air horn. Remove float hinge pin and float. Remove air horn gasket, fuel inlet needle, needle seat, bracket and associated parts.
Remove lifter link, metering rod and spring, and pump hose. Remove main jet using main jet driver (498167100). Remove accelerating pump housing assembly, pump discharge check ball and weight. Separate body from flange. Remove flange gasket, tamper-proof pin and idle mixture screw and spring.