Alternator & Regulator - SEV MOTOROLA: Overhaul: Disassembly

Remove drive pulley and cooling fan. Remove regulator and brush assembly. Remove diode bridge cover. Unsolder 3 stator leads and "D+" leads from diode bridge.
Mark alternator assembly for proper orientation during reassembly. Remove through bolts and carefully separate front housing with rotor from rear housing with stator.
Rotor may be removed from housing after bearing retainer plate screws have been removed.
NOTE: Bearings must be removed and installed using press with adaptors. It is recommended that bearings be replaced whenever alternator is disassembled.
Remove nuts holding diode assembly to rear housing and separate housing and stator. If diodes are faulty, complete assembly must be replaced rather than individual diodes. Use heat sink when making solder connections.