All Models (1963-73)

If ball joints exhibit excessive play, replace as a complete unit. On models using adjustable ball joint, adjust as follows:

1. Detach ball joint from steering knuckle. See appropriate story in SUSPENSION Section. 
2. Remove rubber dust cover from ball joint and release securing flange on tightening cap using an arbor press. Turn cap with suitable tool until ball joint ball joint begins to tighten. Ball joint should move in all directions by hand.
3. Secure tightening cap by bending down flange into grooves on both sides using an arbor press. Lubricate ball joint and install new rubber dust cover. Install ball joint in vehicle.