LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2011 >> RAV4 Base, 2.5 F, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Emission Control System (2AR-FE) (Service Information) >> Purge Valve >> Inspection >> Inspection
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Purge Valve: Inspection: Inspection

  1. INSPECT PURGE VSV 
    Fig 1: Measuring Resistance Of Purge VSV
    GTY222373Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      1 - 2 20°C (68°F) 23 to 26 Ω
      1 - VSV body ground Always 10 MΩ or higher
      2 - VSV body ground 10 MΩ or higher

      If the result is not as specified, replace the purge VSV.

    2. Check the operation of the purge VSV.
        Fig 2: Identifying Purge VSV Component Air Does Not Flow From Port E To Port F
        GTY161423Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Check that air does not flow from port F when air is applied to port E.
        2. Fig 3: Checking VSV Operation
        GTY308557Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Apply battery voltage to the connector, and check the VSV operation.

        OK

        Measurement Condition Specified Condition
        Battery positive (+) → Terminal 1
        Battery negative (-) → Terminal 2        		 Air flows from port E to port F

        If the result is not as specified, replace the purge VSV.

scientia non olet · About LEMON Manuals