Steering Angle Sensor: Removal
WARNING: This page is about a different car, the 2009 Toyota Tacoma. However, it is still accessible from the selected car via links, so may be relevant.
- PRECAUTION
(See AIRBAG SYSTEM )
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
- Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.
- PLACE FRONT WHEELS FACING STRAIGHT AHEAD
- REMOVE STEERING WHEEL COVER LOWER NO. 2 (See REMOVAL )
- REMOVE STEERING WHEEL COVER LOWER NO. 3 (See REMOVAL )
- REMOVE STEERING PAD ASSEMBLY (See INSTALLATION )
- REMOVE STEERING WHEEL ASSEMBLY (See REMOVAL )
- REMOVE STEERING COLUMN COVER LOWER (See SPIRAL CABLE )
- REMOVE STEERING COLUMN COVER UPPER (See SPIRAL CABLE )
- REMOVE SPIRAL CABLE (See SPIRAL CABLE )
- REMOVE STEERING SENSOR
- Release 6 claw fittings and remove the steering sensor from the spiral cable.