LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2010 >> Tundra Base, 4.0 U >> Repair and Diagnosis >> External Pages >> Different car >> Section 342 (Brake Control) >> Steering Angle Sensor >> Installation
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Steering Angle Sensor: Installation

WARNING: This page is about a different car, the 2009 Toyota Tacoma. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL STEERING SENSOR 
    1. Install the steering sensor onto the spiral cable.
    NOTE:
    • Engage the claws securely.
    • Be careful not to damage the claws.
    Fig 1: Identifying Steering Sensor Claw
    G05199382Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE PLACE FRONT WHEELS FACING STRAIGHT AHEAD 
  3. INSTALL SPIRAL CABLE  (See INSPECTION )
  4. CENTER SPIRAL CABLE  (See INSPECTION )
  5. INSTALL STEERING COLUMN COVER UPPER  (See INSTALLATION )
  6. INSTALL STEERING COLUMN COVER LOWER  (See INSTALLATION )
  7. INSTALL STEERING WHEEL ASSEMBLY  (See INSTALLATION )
  8. INSTALL STEERING PAD ASSEMBLY  (See INSTALLATION )
  9. INSTALL STEERING WHEEL COVER LOWER NO. 3  (See INSTALLATION )
  10. INSTALL STEERING WHEEL COVER LOWER NO. 2  (See INSTALLATION )
  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf) 

  12. INSPECT STEERING PAD ASSEMBLY 
  13. INSPECT SRS WARNING LIGHT 

    (See DIAGNOSIS SYSTEM )

scientia non olet · About LEMON Manuals