Front Speed Sensor: Installation

WARNING: This page is about a different car, the 2009 Toyota Tacoma. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT SPEED SENSOR
1. Install the front speed sensor with the bolt.
  Torque: 8.3 N*m (85 kgf*cm, 73 in.*lbf)
  
  NOTE: Make sure that the sensor tip is clean.
2. Connect the speed sensor connector.
Fig 1: Locating Front Speed Sensor Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT WHEEL
Torque: 113 N*m (1152 kgf*cm, 83 ft.*lbf)
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)
CHECK VSC SENSOR SIGNAL (for Hydraulic Brake Booster)
(See TEST MODE PROCEDURE )
CHECK VSC SENSOR SIGNAL (for Vacuum Brake Booster)
(See TEST MODE PROCEDURE )