Distance Control Ecu: Installation

WARNING: This page is about a different car, the 2008 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL DISTANCE CONTROL ECU ASSEMBLY
1. Install the distance control ECU with the bolt.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
  
  NOTE: Do not install the distance control ECU assembly if it has been damaged or received some sort of shock.
2. Connect the connector.
  
  Fig 1: Locating Distance Control ECU With Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH) (See INSTALLATION )
INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD INSERT (See INSTALLATION )
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH (See INSTALLATION )
INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL INSTRUMENT SIDE PANEL LH (See INSTALLATION )
INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH (See INSTALLATION )
INSTALL COWL SIDE TRIM BOARD LH (See INSTALLATION )
INSTALL FRONT DOOR SCUFF PLATE LH (See INSTALLATION )
INITIALIZE DISTANCE CONTROL ECU
1. Initialize the distance control ECU (See INITIALIZATION ).