Cruise Control Main Switch: Installation

WARNING: This page is about a different car, the 2008 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL CRUISE CONTROL MAIN SWITCH
1. Install the switch, as shown in the illustration.
  
  Fig 1: Locating Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the 2 screws.
3. Connect the connector.
INSTALL STEERING PAD (See INSTALLATION )
INSTALL LOWER NO. 3 STEERING WHEEL COVER (See INSTALLATION )
INSTALL LOWER NO. 2 STEERING WHEEL COVER (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Fig 2: Locating Connector And Screw
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NOTE: When disconnecting the cable some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).

Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
INSPECT SRS WARNING LIGHT
1. Inspect the SRS warning light (See DIAGNOSIS SYSTEM ).