Brake Actuator: Removal

WARNING: This page is about a different car, the 2009 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.

DISCONNECT VSC ACTUATOR CONNECTOR
1. Pull the release bar and disconnect the VSC actuator connector.
  NOTE: Be careful not to allow brake fluid to enter the removed connector.
  
  Fig 1: Pulling Release Bar
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE BRAKE TUBE
1. Use tags or make a note to identify the reconnection locations.
  
  Fig 2: Identifying Brake Tube
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a union nut wrench, disconnect the 2 brake tubes from the VSC actuator.
  
  Fig 3: Identifying Union Nut Wrench
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using a union nut wrench, remove the 2 brake tubes from the brake master cylinder.
  
  Fig 4: Locating Union Nut Wrench
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
DISCONNECT BRAKE TUBE
1. Using a union nut wrench, disconnect the 4 brake tubes from the VSC actuator.
2. Remove the clamp from the VSC actuator bracket.
  
  Fig 5: Locating Brake Tube
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE VSC ACTUATOR WITH ACTUATOR BRACKET ASSEMBLY
1. Remove the 3 nuts and VSC actuator with actuator bracket.
  NOTE: Do not damage the brake lines or wire harness.
  
  Fig 6: Locating VSC Actuator With Actuator Bracket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002