Inspection Procedure
WARNING: This page is about a different car, the 2009 Toyota Tacoma. However, it is still accessible from the selected car via links, so may be relevant.
- READ OUTPUT DTC (CURRENT DTC)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON and turn the Techstream ON.
- Enter the following menus: Powertrain/Engine and ECT/Trouble Codes.
- Read DTCs.
Result
RESULT CHARTDisplay (DTC Output) Proceed to P0630 A P0630 and other DTCs B If any DTCs other than P0630 are output, troubleshoot those DTCs first.
NOTE: If P0630 is set, the VIN must be input to the ECM using the Techstream. However, all DTCs are cleared automatically by the Techstream when inputting the VIN. If DTCs other than P0630 are set, check them first.B: GO TO DTC CHART
A: Go to next step
- INPUT VIN WITH TECHSTREAM
- Input the VIN (See REGISTRATION
).
NEXT: END
- Input the VIN (See REGISTRATION
).