Heated Oxygen Sensor: Installation

INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)
1. Install the sensor to the exhaust pipe by hand.
  
  Fig 1: Installing Sensor To Exhaust Pipe
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using SST, tighten the sensor.
  SST 09224-00010
  
  Torque: without SST
  
  44 N*m (449 kgf*cm, 32 ft.*lbf)
  
  with SST
  
  40 N*m (408 kgf*cm, 30 ft.*lbf)
  
  HINT:
  - Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). If using a torque wrench with a length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (see REPAIR INSTRUCTION ).
  - Make sure SST and the wrench are connected in a straight line.
    
    Fig 2: Identifying SST 09224-00010 & Fulcrum Length
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
1. Install the sensor to the exhaust pipe by hand.
  
  Fig 3: Installing Sensor To Exhaust Pipe
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using SST, tighten the sensor.
  SST 09224-00010
  
  Torque: without SST
  
  44 N*m (449 kgf*cm, 32 ft.*lbf)
  
  with SST
  
  40 N*m (408 kgf*cm, 30 ft.*lbf)
  
  HINT:
  - Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). If using a torque wrench with a length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (see REPAIR INSTRUCTION ).
  - Make sure SST and the wrench are connected in a straight line.
    
    Fig 4: Identifying SST 09224-00010 & Fulcrum Length
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT EXHAUST PIPE ASSEMBLY (See INSTALLATION )
INSTALL FRONT NO. 2 EXHAUST PIPE ASSEMBLY (for Regular Cab Standard Deck) (See INSTALLATION )
INSTALL FRONT NO. 2 EXHAUST PIPE ASSEMBLY (except Regular Cab Standard Deck) (See INSTALLATION )
INSTALL FRONT PROPELLER SHAFT ASSEMBLY (for 4WD) (See INSTALLATION )
INSTALL PROPELLER SHAFT HEAT INSULATOR (for 4WD) (See INSTALLATION )
INSPECT FOR EXHAUST GAS LEAK . (See EXHAUST MANIFOLD ).