LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2008 >> Highlander Base, FWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System (2GR-FE Except Hybrid) - System Testing, On-Vehicle Inspection, Removal, Inspection And Installation >> Engine Coolant Temperature Sensor >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Engine Coolant Temperature Sensor: Removal

  1. REMOVE V-BANK COVER SUB-ASSEMBLY  (See REMOVAL )
  2. REMOVE ENGINE UNDER COVER ASSEMBLY  (See REMOVAL )
  3. REMOVE NO. 1 ENGINE UNDER COVER  (See REMOVAL )
  4. DRAIN ENGINE COOLANT  (See REPLACEMENT )
  5. REMOVE COOL AIR INTAKE DUCT SEAL  (See REMOVAL )
  6. REMOVE BATTERY  (See REMOVAL )
  7. REMOVE NO. 2 AIR CLEANER INLET  (See REMOVAL )
  8. REMOVE NO. 1 AIR CLEANER INLET  (See REMOVAL )
  9. REMOVE AIR CLEANER CAP SUB-ASSEMBLY  (See REMOVAL )
  10. REMOVE AIR CLEANER CASE SUB-ASSEMBLY  (See REMOVAL )
  11. REMOVE ENGINE COOLANT TEMPERATURE SENSOR 
    1. Disconnect the engine coolant temperature sensor connector.
      Fig 1: Identifying Engine Coolant Temperature Sensor Connector
      G05414062Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the engine coolant temperature sensor and gasket.
scientia non olet · About LEMON Manuals