LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2008 >> Highlander Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Brake Control - Hybrid) >> Steering Angle Sensor >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Steering Angle Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
  1. PRECAUTION 
    CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing (See PRECAUTION ).
  2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD 
  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait for at least 90 seconds after disconnecting the cable to prevent airbag deployment.
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  4. REMOVE LOWER NO. 3 STEERING WHEEL COVER  (See REMOVAL )
  5. REMOVE LOWER NO. 2 STEERING WHEEL COVER  (See REMOVAL )
  6. REMOVE STEERING PAD  (See REMOVAL )
  7. REMOVE STEERING WHEEL ASSEMBLY  (See REMOVAL )
  8. REMOVE STEERING COLUMN COVER  (See REMOVAL )
  9. REMOVE SPIRAL CABLE WITH STEERING ANGLE SENSOR  (See REMOVAL )
  10. REMOVE STEERING ANGLE SENSOR 
    1. Disengage the 6 claws and 2 pins, and remove the steering angle sensor from the spiral cable.
      Fig 1: Identifying Steering Angle Sensor With Claws And Pins
      G05417858Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals