Inspection Procedure

WARNING: This page is about a different car, the 2007 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.

PERFORM ACTIVE TEST USING INTELLIGENT TESTER

Connect the intelligent tester to the DLC3.

Check the CRUISE main indicator light by performing the ACTIVE TEST.

Combination meter:

INSPECTION PROCEDURE REFERENCE CHART

Tester Display	Test Part	Control Range	Normal Condition
CRUISE INDIC	CRUISE main indicator light	Indicator light BLINK / OFF	-

OK:

Indicator light comes on/goes off.

NG: REPLACE COMBINATION METER ASSEMBLY

OK: Go to next step

READ VALUE ON INTELLIGENT TESTER

Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position and turn the intelligent tester main switch on.

Check the DATA LIST for proper functioning of the CRUISE main indicator light.

ECM (Cruise control):

DATA LIST REFERENCE

Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
CCS INDICATOR M	Cruise indicator signal (Main CPU) / ON or OFF	ON: "CRUISE" on OFF: "CRUISE" off	-

OK:

When the cruise control main switch is operated, the display changes as shown above.

NG: REPLACE ECM

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE