Crankshaft Position Sensor: Removal
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTE:
- Some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
- After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
- REMOVE NO. 1 ENGINE UNDER COVER (See REMOVAL )
- REMOVE FAN AND GENERATOR V BELT (See REMOVAL )
- REMOVE GENERATOR ASSEMBLY (See REMOVAL )
- DISCONNECT COOLER COMPRESSOR ASSEMBLY (See REMOVAL )
- REMOVE CRANKSHAFT POSITION SENSOR
- Disconnect the sensor connector.
- Remove the bolt and sensor.