LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2007 >> Sienna XLE, AWD >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Engine Fuel System >> Fuel Pressure Pulsation Damper >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Fuel Pressure Pulsation Damper: Installation

  1. INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY 
    1. Apply a light coat of spindle oil or gasoline to a new O-ring and install it to the fuel pressure pulsation damper.
    2. Install the fuel pressure pulsation damper to the fuel delivery pipe.
    3. Install the clip.
      Fig 1: Identifying Pulsation Damper And O-Ring
      G05138210Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL INTAKE AIR SURGE TANK ASSEMBLY  (See INSTALLATION  )
  3. INSTALL AIR CLEANER CAP SUB-ASSEMBLY  (See INSTALLATION  )
  4. ADD ENGINE COOLANT  (See REPLACEMENT )
  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  6. INSPECT FOR ENGINE COOLANT LEAK  (See ON-VEHICLE INSPECTION )
  7. INSTALL NO. 1 ENGINE UNDER COVER 
  8. INSPECT FOR FUEL LEAK  (See ON-VEHICLE INSPECTION  )
  9. INSTALL V-BANK COVER SUB-ASSEMBLY  (See INSTALLATION )
  10. INSTALL COWL TOP PANEL SUB-ASSEMBLY OUTER FRONT  (See INSTALLATION  )
  11. INSTALL NO. 1 COWL TOP TO COWL BRACE INNER  (See INSTALLATION  )
  12. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY  (See INSTALLATION )
  13. INSTALL FRONT WIPER ARM LH  (See INSTALLATION )
  14. INSTALL FRONT WIPER ARM RH  (See INSTALLATION )
scientia non olet · About LEMON Manuals