LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2007 >> Camry CE, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 27 (Engine Control System (Hybrid)) >> SFI System >> DTC P0607: Control Module Performance >> Inspection Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Inspection Procedure

WARNING: This page is about a different variant/trim than selected.
  1. CHECK WHETHER DTC OUTPUT RECURS (IN ADDITION TO DTC P0607) 
    1. Connect the intelligent tester to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the tester on.
    4. Clear the DTC.
    5. Turn the engine switch off.
    6. Disconnect the battery negative terminal and wait for 1 minute.
    7. Connect the battery negative terminal.
    8. Turn the engine switch on (IG).
    9. Enter the following menus: DIAGNOSIS / ENHANCED / DTC INFO / CURRENT CODES.
    10. Read the DTCs.

      Result 

      RESULT REFERENCE

      Display (DTC output) Proceed to
      P0607 A
      No output DTC B

    B: CHECK FOR INTERMITTENT PROBLEMS 

    A: REPLACE HYBRID VEHICLE CONTROL ECU 

scientia non olet · About LEMON Manuals